Search results

Its with everything including calibration tones from the audyssey setup and the THX setup from the Terminator 2 BluRay All the wire ends are soldered right now to prevent any wire splinters  :(

Swapping of the wires showed its the channel and not the speaker + wires. A few months ago I even trimmed all of the ends of the wire and soldered them to make sure there is no loose strands that might be accidentally be causing a short or something.

As for the setup screen the right channel is turned as far down as possible, where the center channel is turned up as high as possible, then I still have to bump up the center channel  even more with the remote. So as long as the amp doesn't cut out its ok as its right now, but something isn't...

I just did it again to confirm and its a fault with the amp. The other speaker on the left channel is still way softer than the right channel. To get them sort of equal I had to set them as such in the speaker config: Left:      +6db Center: +12db Right:    -12db

I performed a Factory reset on it, and I'm still unable to perform the auto calibration. If I place the microhone 30cm from the speaker it does get picked up. I also noticed the left front speaker is considrebly softer than the right front one. It might be why the calibration fails to detect the...

Thanks, I will do so.

Just the receiver? Or the speakers aswell?

Amp: NAD T755 Speakers: Mission MV cinema pack Issue 1: After a watching TV for a few hours, usually if it gets to a loader scene, the receiver switches itself off into a protection mode (power LED turns red), and then I have to remove the power to the amp, before it clears and I can turn the...