Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="lanties" data-source="post: 455377" data-attributes="member: 13832">^^^ Basically all of the above. I am busy building some speakers and with the help of some members here have learned lots and have actually managed to get the speakers to a decent stage, but as you know it never stops with one set or a final cross over. I have the DATS system for measuring T/S parameters as well as impedance and Omnimic for frequency response, I know I can do this with SE as well but I already have all the measurements I need at this stage and as far as I believe I should have. I was hoping to just load this into SE and start modelling boxes and XO's I know modelling boxes at this stage is a bit of a waste of time as all the boxes have been build but it is also part of the learning process. The next step should also to start to design and optimize the XOs but things are falling apart a bit as I know I should have in box frequency responses loaded etc but it is not obvious where and how to do all of this and even if SE can work with Omnimic's FRD files.</blockquote>