Hi all
I purchased a LP12 from someone last week, it is in good cosmetic condition but the power supply has a blown fuse and from what I can see there are also two blown resistors. While examining the board I noticed some "mods" were performed on it (just before where the motor wires connects to the board), can any of the more knowledgeable guys explain to me what the purpose of these "mods" were and if I should leave them or remove them?
Then on another note, apart from the caps what else should I replace on the board? R2 and R3 are probably prime candidates for replacement?
Thanks
J.
I purchased a LP12 from someone last week, it is in good cosmetic condition but the power supply has a blown fuse and from what I can see there are also two blown resistors. While examining the board I noticed some "mods" were performed on it (just before where the motor wires connects to the board), can any of the more knowledgeable guys explain to me what the purpose of these "mods" were and if I should leave them or remove them?
Then on another note, apart from the caps what else should I replace on the board? R2 and R3 are probably prime candidates for replacement?
Thanks
J.
