Ok, I think I've figured out how to cut thh hole for the driver
Start off 1st by cutting the 8mm edge for the driver to sit in the cut the hole out afterwards.
The question is how do you cut the centre piece out? Surely it will fall through as you're about to finish?
Can I simply attach anoth piece of wood from the underneath to hold it or should I clamp a section underneath so I can cut through to it?
Start off 1st by cutting the 8mm edge for the driver to sit in the cut the hole out afterwards.
The question is how do you cut the centre piece out? Surely it will fall through as you're about to finish?
Can I simply attach anoth piece of wood from the underneath to hold it or should I clamp a section underneath so I can cut through to it?
